Looking at the picture, invisible car window shade is the most unqualified product with the worst quality. Car window shade is of poor quality. Basically, the spring cannot pop up after a long time.
If the spring can pop up, then use the hand to break the handle outward. Generally, there is a hook below to break off the hook and it can automatically pop up.
If you open the lower pull beam, you can only use your hands or other tools to force reel on the top to see if it can pop back.
If it doesn't work, you can only disassemble it. If it is broken and cannot be used, you can only replace it with a new one. Remember to replace it with a good quality one.
First of all, you need to know its structure: when the glass window is pushed open, the voile is unfolded with the glass window to block the open part. When the glass window is closed, the voile is under the spring elasticity of the winding mechanism, it is wrapped on the inner shaft and collected in the main pipe, which does not occupy space and does not affect the appearance of the window.
As long as the buckle is opened, the shutter car window shade will automatically pop up.
The steps are as follows: if you remove the bottom slot first, you will see two slipping buckles, remove the screws to the slide, and the screws on the box will be seen, remove the screws, that's it.
Invisible car window shade buckle removal method; You can try this method, use a screwdriver to gently pry the bottom groove, there are fixed buckle on the track plugs on both sides, there are 1-2 fixed buckle in the middle, from the screw position on the reverse side. If you can see the position of fixed buckle, you must be close to the buckle to prevent the profile from being deformed.
1. Pull out the invisible car window shade handle slightly by 10 centimeters. Then slowly pull car window shade reel out of the house.
2. Some invisible car window shade accessories have a hook. You just need to pull the hook out first. The same is true.
3. Car window shade reel after taking it out. Then move out the aluminum alloy at the handle.
4. Be careful not to get stuck to the corners when taking voile, causing voile to break.
5. Pull out the car window shade when washing. After pulling it out, you can see a round tube inside the reel. Then just take a cloth and put it into reel.
Next, clean the invisible car window shade and wash it on a flat surface. You can put some washing powder and brush it.
Dust: first use a soft brush to gently brush the floating dust on both sides, then use two pieces of sponge or plastic foam, dip some washing powder solution or soap water, and hold one piece in one hand, hold the same part of car window shade from both sides, wipe it from top to bottom first, then from left to right; Finally, dip it in clean water and gently wipe it, so that all the dust on the car window shade can be removed.
Oil Dirt: put several layers of old newspapers on the kitchen floor, take car window shade of the roll back, put old newspapers on it, and scrape them hard with wooden spoon and so on, so that most of the oil stains stick to the old newspapers, change the newspaper repeatedly to stick oil. Until most of the oil stains are stuck off by newspapers, brush around with wire brush and detergent. Finally, clean them with a wet rag and apply a little oil to prevent rust.
