Method 1:
When the installation position changes, the fixed plastic-steel frame may not be equidistant, and the upper and lower frames may not be parallel.
The spacing is large, find the place where the spacing is the largest to install.
The removed car window shade frame may be deformed due to stress. Look at the poor distance during installation and rub it with wood.
Shutter invisible screen disassembly method: Pull out the handle of invisible screen slightly by 10 centimeters, and slowly pull out the handle of car window shade reel Super home.
Some invisible screen accessories have hooks, first move the hooks out, the same reason.
Car window shade reel after taking it out, remove the aluminum alloy at the handle and install it.
Method 2:
1. First, put the upper end well, grab the middle part and pull out hard. At the same time, use the other hand or another person to help, and push the lower end inside.
2. The original meaning of "grab the middle part and pull out hard" is to bend it into an arch!
3. After the position above is right, gently kick the bottom with your feet, then enter the bottom, and then fine-tune it with your hands. The whole process takes about 30 seconds.
4. Press the top first, then put your feet on the bottom, and put your hands on the bottom in the middle.
5. Move the middle part of the left side of the car window shade with your right hand and pull it outward.
6. After the upper part is installed, install the left side of car window shade First, move the middle part of the right side of car window shade and pull it outward. At the same time, push the lower part of the left side upward and inward car window shade, and then go up!
Push-pull car window shade installation:
1. Hold your hands on both sides of the car window shade frame and top it up. If you can't top it up, it means that it may be too long to accumulate dust and sundries in the track. It is not enough to put it on the top, naturally, it cannot be taken out. In this case, the track slot should be cleaned after being removed.
2. Hold the car window shade frame hands close to the middle position on both sides, and push it out or inside horizontally. (if there are more seats there, it will face there) because the flexibility of plastic steel is good, it should be easy to take it off. But this is best done by a man. A woman has a little strength, and the balance of force should not be as good as a man. If it is not done, the car window shade boxes will be broken.
Method 3:
There are several ways to install car window shade:
1. The correct approach is to first install the upper end, grab the middle part and pull out hard. At the same time, use the other hand or another person to help, and push the lower end inside.
2. Insert car window shade into the upper part obliquely, and then use a little force to enter the lower groove.
3. When installing, you can put it on first, then top it up. After the top is over, it should fall on the slide below after pushing it down. If you can't push in below, you can use the other hand to hold the middle of the yarn fan material and pull out, so if you bend it, you can push in below.
4. Put the bottom into the slot first, put the head forward against the top, and pull the bow head back on the left and right sides to push forward.
5. In the place with the largest space in the height, go up to the top first, on one side, pull the middle with one hand, pull to the pull, not afraid of its elasticity, push one hand in the bottom.
