Cutting: when cutting the glass film, its length is one centimeter higher than that of the glass.
Cleaning Glass: clean the glass before the glass pasting film, and then spray some water on the cleaned glass to reduce the viscosity of the glass film, so that its viscosity will not be affected after drying.
Remove the other side release film: After removing release film, sprinkle some water on the back of the glass film, which can facilitate the construction of the back, so that the film can be moved during the paving process to find a suitable position.
Paving: measure the size of the glass, align the upper end of the glass, and paste it from top to bottom. If it is not aligned at one time, you can tear it off again and spread it. This is the advantage of sprinkling water mentioned above.
Bubble discharge: Use a scraper to scrape out the bubbles in the film. If the bubbles cannot be discharged, use a needle to break them and then smooth them, so that they can completely stick to the glass.
Cut the remaining part: After the paving is completed, use the blade to cut off the excess part.
In addition to paying attention to how to paste the glass film, the glass must be thoroughly cleaned. When cleaning, spray more water and then use a scraper to scrape it several times, make sure there is no dust, sand, etc. on the glass, and then sprinkle a layer of water after the glass is cleaned.
Before applying the film, spray some lubricant to make its adhesive layer less viscous, and then tear the film on the edge of the protective film. Secondly, to determine the position of the glass film, you can first make a cross, then scrape the film from both sides, fix the film, and then scrape the bubbles out with a scraper.
After the construction of the glass film is completed, spray a little detergent on the glass and wipe it clean with a rag, which can effectively remove the residues on the surface and make the glass brighter.
The film is divided into two layers. The transparent layer is called negative film, and the with adhesive tape layer is called positive film.
The film is a very crisp product, please do not touch hard objects and folds, please choose to stick the film indoors.
Clean the glass with a small amount of pure water detergent for more than three times
Spray water again before applying the film to facilitate the positioning and movement of the film.
Use a small piece of tape to stick the corner of the solar film and gently open the transparent layer
Spray water evenly to the adhesive layer of solar film to prevent sticking to impurities
Tear off the transparent layer and stick the adhesive layer to the indoor side of the glass
Move the solar film to a suitable position, spray water and paste the transparent layer to prevent the film from scratching
Cross from the middle and scrape the water out evenly to both sides.
Then use a knife to repair the four long sides of the window along the window edge.
Use towel with scraper to absorb the moisture on the window edge and press the edge to soak
