When choosing entry door, most families will buy anti-theft doors, and the size of the anti-theft doors is the key factor when we buy anti-theft doors. Therefore, when measuring the size of the anti-theft doors, we should pay attention to the measurement method. The following small editor will take you to see how to measure the size of the security door and the size of the general security door.
Anti-theft door is equipped with security lock, which can resist abnormal opening under certain conditions within a certain period of time, has certain security protection performance and meets the corresponding anti-theft security level.
When choosing entry door, most families will buy anti-theft doors, and the size of the anti-theft doors is the key factor when we buy anti-theft doors. Therefore, when measuring the size of the anti-theft doors, we should pay attention to the measurement method. The following editor will show you how to measure the size of the security door, and the size of the general security door.
How to measure the size of the security door?
First measure the width (upper, middle and lower points) with China's standard 5 m tape measure, then measure the height (left, middle and right points), then take the above width, the minimum height is the target size. Finally, measure the wall thickness, measure the thickness of the left and right walls and the top walls respectively, and take the maximum value as the target size.
Buyang security door (Image Source: Buyang official flagship store, invasion and deletion)
door hole measurement: when measuring the door hole, the height of the door hole needs to be measured first. The height is from the ground to the top of the door hole, and both sides need to be measured. To measure the width of the door opening, it should be divided into three points: upper, middle and lower, and the inside and outside holes should be measured to see if the data is consistent. When measuring the wall thickness, it should also be divided into three points: upper, middle and lower, both of them need to be measured. Finally, record the measurement results on the wall.
Entry door single-sided door opening measurement: first measure the height; Then measure the width. Because the right side of entrance door does not have gate stack, the lines of the whole wooden door cannot be installed during installation, therefore, it is necessary to install a fake gate stack here, the thickness of gate stack is 4 centimeters, and the width is the width of the wall. Then, the thickness of gate stack is deducted according to the entrance of the door opening, and the final data is the width of the door; Finally, the thickness of the wall is measured.
Buyang security door (Photo source: Buyang official flagship store, invasion and deletion)
kitchen and bathroom door hole measurement: the measurement method is basically the same as that of bedroom door, but it should be noted that when measuring rough houses, the thickness of tiles should be taken into account, therefore, it is necessary to add 2cm to the measured data.
Sliding Door single-sided door hole measurement: measure the height, width and thickness of the wooden hole respectively, which is consistent with the measurement method of the bedroom door hole.
What is the general size of security door?
There are four types of standard security doors:
1.860 width × 2050 height
2.960 width × 2050 height
3.960 width × 1970 HEIGHT
4.860 width × 1970 HEIGHT
the height of 2050mm is a door frame with a total height of 2.05 meters. If the height of the door opening is 2070mm, you can buy it.
How to measure the size of the security door, and the size of the general security door is introduced here, if you want to know more about door and window products and related knowledge, please continue to pay attention to Zhonghua door and window network.
(Article Source: install a network today's headlines, invasion and deletion)
