Wooden doors have a long history in China. Although there are basically special decoration teams for door-to-door installation, many people still hope to clearly understand the detailed process of solid wood door installation plan, so today I will take you to have a look, what is the whole record of the installation method of the indoor wooden door.
Solid wood door installation plan
installation method of indoor wooden door I. Make preparations
when you arrive at the scene in the morning, unpack all the packages and arrange the door leaf, door set and motherboard.
Accessories are also ready
the master has started to install the connecting sleeve plate.
Sealing Strip is stuck on the door casing position, which has better sound insulation effect
installation method of indoor wooden door II. Installation of door cover
stand the connected motherboard in the middle of the door opening and adjust the verticality with a level to avoid gaps when installing the door leaf at the back.
Connect the steel nail that has entered the wall with wooden wedge to fix the door cover.
Play Styrofoam in the gap between the wall and the motherboard to make it more stable.
In this way, the wall and door set become a whole.
Installation method of indoor wooden door III. Installation of door leaf hardware
open the door with loose-leaf connection door cover plate, sliding door with pulley connection cover plate, first of all, open a hardware position on the door leaf, so that the back head screw fixed connection.
Then cut the surface of the door leaf about 3cm, you can clearly see that the interior is real wood, and there is no gap.
The last screw tightening is fixed. Special note: The door is generally heavy, please do not buy sub-mother hinge, its weight capacity is not good.
Installation method of indoor wooden door IV. Installation of door leaf
fix it with screws first and connect the door leaf door set through loose leaf.
Then adjust the horizontal verticality of the door leaf with the help of level meter and taping.
Finally, close the door and check to make sure there is almost no gap and then fix it.
Installation method of indoor wooden door v. Installation line door latch
the ground is uneven, use chisel to knock out the cement door set around the rice crust.
The buckle wire is installed with a 90-degree angle and a 45-degree angle. The installer asks the owner to determine which way to measure the size and cut the buckle wire.
Hit Styrofoam
buckle into the motherboard slot
adjust the level and connect the flat buckle line and the vertical buckle line
make sure the buckle is fully fastened motherboard card slot
installation method of indoor wooden door VI. Complete installation of door lock
draw the lock cylinder position first, and then open the hole.
You can see the material inside the wooden door.
After the door lock is installed, the effect of the door comes out.
Installation method of indoor wooden door 7. Do a good job of protection
cover the door leaf with a protective film, so as not to spill painting behind the door leaf. It is really difficult to clean up after the paint is dry.
Installation method of indoor wooden door 8. Look at the details
check the front of the door from far to near: first look at the overall effect, the wood grain effect is obvious, comparable to wooden door. It is shot within one meter, the wood grain is fine, and the paint effect is very good.
The above is the detailed process of the solid wood door installation plan. The installation method of the indoor wooden door is recorded. Everyone knows it. If you want to know more about wooden door products and related knowledge, please continue to pay attention to China wooden door network.
(Source of text and text: both doors, invasion and deletion)