There are mainly three kinds of wardrobes sold in the market now, namely push-pull wardrobe, flat wardrobe and open wardrobe. However, how to install closet door? Different wardrobes have different installation methods, among which the open wardrobe is not closet door, so it is not within the scope of discussion.
There are mainly three kinds of wardrobes sold in the market now, namely push-pull wardrobe, flat wardrobe and open wardrobe. However, how to install closet door? Different wardrobes have different installation methods, among which the open wardrobe is not closet door, so it is not within the scope of discussion.
Push-pull wardrobe
push-pull wardrobe refers to the wardrobe whose cabinet body is closely connected with the wall and is mainly switched through sliding door. Its installation focuses on the installation of sliding door, which is realized by pulley.
First of all, install the guide rail on the wardrobe, measure the size of both sides clearly, place the track in the middle of door set, position and drill holes on both sides, and then drill the hole in the middle after fixing the guide rail. Then, locate the male drawer guide and put the sliding door into the upper male drawer guide to adjust the position constantly to find the best sliding effect. Finally, clean the guide rail with a fine brush, install the upper pulley first, raise the sliding door vigorously, and place the lower pulley in the guide rail. In addition, after the installation of sliding door is completed, bumper strip should be attached on both sides to avoid damage to sliding door.
Flat wardrobe
flat wardrobe is a relatively traditional wardrobe style, which mainly connects the Cabinet body with closet door through wardrobe hinge. Therefore, its installation is mainly the installation of wardrobe hinge.
If the closet door covers the Cabinet completely, the extended arm with closet door of 0mm should be selected. During installation, a certain gap should be reserved between the cabinet and the cabinet door to facilitate opening of the wardrobe. If closet door covers the cabinet half, and two cabinet doors share one cabinet side panel, a small gap must be left between the two cabinet doors, at the same time, a door hinge with a curve of 9.5mm should be installed. If two cabinet doors share one cabinet body, a door hinge with a curve of 16mm should be installed. After the wardrobe hinge is installed, it still needs to be adjusted constantly, so that the cabinet door is installed at the most pinpoint, which is convenient for the use of the wardrobe.
Which type does your wardrobe belong? There are different installation methods for different wardrobes. After knowing this knowledge, do you know how to install closet door?
