Many people pay less attention to door and window hardware when choosing doors and windows. A good roller skating can not only reduce noise, but also prolong the service life of doors and windows. The following door hardware installation will introduce the replacement steps of door and window sliding wheel in detail for your reference.
When choosing doors and windows, many people will consider glass and profiles in many aspects, but pay less attention to door and window hardware.
Although the pulley seems to be a relatively simple hardware accessory for doors and windows, the frequency of use is relatively high. A good roller skating can not only reduce noise, but also prolong the service life of doors and windows. The following door hardware installation will introduce the replacement steps of door and window sliding wheel in detail for your reference.
Door and window sliding wheel replacement procedure
1. First, set up the upper pulley part of slide door during replacement, which will facilitate the following steps.
2. Remember to pull wool tops, you can insert 6mm hexagonal wrench from the round hole, which is the most suitable.
3. If you feel that it is hard to twist, you can use the short end of the wrench to insert the inner six holes of the Screw, and then rotate it.
4. After loosening the screw, the door-to-door window pulley can be pulled out in parallel at this time.
5. Then screw in the new screw to install it.
6. Push upper pulley flat into the gap between the screw cap and the inner wall of the door frame. This is to keep the upper pulley at a certain distance, and remember to leave a upper pulley between the upper edge of the door frame and the plane of the cardboard.
7. Then tighten the screws.
8. Upper pulley is installed. At this time, you can take off cardboard.
9. Turn slide door over and tree up
, at this time, the screw can be inserted through the round hole at the bottom, and the lower door and window sliding wheel can be held down by hand. In this way, the screw hole of the square can be adjusted to be perpendicular to the screw, so that the screw can be easily screwed in, use a 5mm hexagonal wrench to twist the screws.
10. After the screw is screwed into the adjustment square, it will be OK to rotate it five times. At this point, slide door is installed on one side and lower pulley. The installation methods of other upper and lower door and window sliding wheel are the same.
11. If slide door is not flat after being installed on the slide rail, you can use a 6mm hexagonal wrench to continue adjusting it at this time. Clockwise rotation is raised and counterclockwise rotation is lowered.
In the door and window hardware, door and window sliding wheel of the installation steps are carried out according to the above. Basically, it is completed. The installation of door hardware is simple, but there are also many things to pay attention, if you can't handle it alone, it is also a good choice to ask a professional to install it.
(Graphic Source: oubaolai public number, invasion and deletion)
