Plastic steel doors and windows are good-looking and durable, which is commonly used for installing windows at home nowadays. If the plastic steel doors and windows in the home fail, disassembly may be involved, do you know how to disassemble plastic steel doors and windows? It is not difficult to dismantle plastic steel doors and windows, but there are some skills. Interested friends should come and have a look.
Plastic steel doors and windows are good-looking and durable, which is commonly used for installing windows at home nowadays. If the plastic steel doors and windows in the home fail, disassembly may be involved, do you know how to disassemble plastic steel doors and windows?
It is not difficult to dismantle plastic steel doors and windows, but there are some skills. Next, the editor will give netizens a brief talk about how to dismantle plastic steel doors and windows. Interested friends should come and have a look.
How to disassemble plastic steel doors and windows:
first, push the two windows together to overlap, hold the Casement against the outside with both hands, lift it up with force, then slightly outward, move the lower part of the Casement out of the window track, then hold the Casement down with force, the upper part of Casement is out of the window frame. The Casement inside can also be taken off like this, because the Casement outside has been taken off, which is more convenient to remove. Pay attention to safety when disassembling plastic steel windows. In order to prevent depravity, it is better for two people to cooperate.
But sometimes casement may not be lifted, because the plastic strip on the side is limited. You can carefully observe the groove on the side of Casement, which is also called anti-theft board, it is stuck with a plastic clip. You can use a screwdriver to gently pry it down along the gap. You can remove it at Casement and install the anti-theft board after completion. If there is a window lock to block it, remove the lock.
In addition, there is a protruding object in the groove on the top of the plastic steel door and window frame, which may block Casement and cannot be removed. The function of this object is a limit, which is fixed with screws or can be removed. But it is installed on the side and should not touch it.
How to Change glass for plastic steel doors and windows:
remove the cullet first: use a putty knife or a thin blade to remove the glass layering First, remove two long layering strips, then remove two short ones, and finally take off the double-layer glass to clean up the fragments. Be careful not to hurt the contact surface of the sealing strip caught in the middle, and use a putty knife to insert and cut it flat.
Replace the new glass: Clean the new glass wiper and wipe the inner surface of the original layer of glass clean at the same time, otherwise it will not be wiped when it is installed. Clean the contact surface of the sealing strip, put the glass, make sure there are no sundries and dust inside, and seal it with silicon sealant.
Put back the Glass: After the silicon sealant is 80% dry, put back the double-layer glass, contrary to the time when it is removed, first install the short layering, and then install the long layering. Then polish the glass and replace the plastic steel door window glass.
How to disassemble plastic steel doors and windows is introduced here. I believe that after reading the above introduction, everyone has a certain understanding of how to disassemble plastic steel doors and windows, if you want to know more about door and window products and related knowledge, please continue to pay attention to Zhonghua door and window network.
(Article Source: Today's headlines, invasion and deletion)
