Glass door clamp is a hardware accessory fixed on the edge of a glass door to install other components. At present, glass door clamp of the products sold on the market are of various types, such as door clip, word clip, head clip, etc. The materials are also different, but generally they are mainly metal. Today's knowledge of installing glass doors, let's talk about glass door hardware accessories, glass door clamp specific installation steps for your reference.
Glass door clamp is a hardware accessory fixed on the edge of a glass door to install other components. At present, glass door clamp of the products sold on the market are of various types, such as door clip, word clip, head clip, etc. The materials are also different, but generally they are mainly metal.
Today's knowledge of installing glass doors, let's talk about glass door hardware accessories, glass door clamp specific installation steps for your reference.
Step1: positioning and pay-off
fixed glass and movable glass door leaf combination glass door, unified pay-off positioning, according to the design and construction drawings requirements, release the glass door positioning line, and determine the door frame position.
Step2: Installation of limit slot on top of frame
the width of the limit groove should be two to four millimeters greater than the thickness of the glass, and the depth of the groove should be ten to twenty millimeters. During installation, at the beginning, two metal decorative board edges are led out by the bullet line, then the top limit groove of the door frame is installed according to the edge line, and the groove depth in the groove is adjusted through the glued backing plate.
Step3: metal finish wood base support installation
fix the square wood on the ground and stick the metal all-purpose adhesive on the wood with trim board. If aluminum alloy square tube is used, it can be fixed on the frame column with aluminum angle, or fixed on the wooden brick buried in the ground with wood screw.
Step4: vertical door frame installation
the bullet center line is connected to nail the square wood of the door frame, then use plywood to determine the shape and position of the door frame column, and finally the metal decorative surface is outsourced. When wrapping up the finish, put the opposite joint position of the finish on the middle door position on both sides of the glass installation.
Step5: install glass
use glass suction tray machine to suck the thick glass tightly and lift the thick glass plate to the installation position. First insert the upper part of the glass into the limit groove at the top of the door frame, and then put the lower part of the glass on the base support.
Step6: fixed glass
the inside and outside nails on base support square wood two small square wooden strips clamp thick glass on the middle door, paint all-purpose adhesive on the square wood strips and stick the decorative metal on the square wood strips.
Step7: note silicon sealant sealing
on both sides of the top limit groove and the bottom bracket ports, as well as the gaps between the thick glass and the frame column, inject silicon sealant to seal, and scrape off the excess silicon sealant with tools.
Step8: glass docking
when the fixed part of the glass door needs to be spliced due to over dimension, its butt seam should have a width of two to three millimeters, and the edge of the glass plate should be chamfered.
The above is about the installation of glass doors, glass door hardware accessories, glass door clamp specific steps for installation, if you want to know more about the products of doors and windows and related knowledge, please continue to pay attention to Zhonghua door and window network.
(Article Source: WeChat of Gaoyao Yongxing hardware floor spring factory , invasion and deletion)
