In addition to choosing the quality of the product itself, consumers should not despise after-sales work such as installing wooden doors when purchasing wooden doors. Only good wooden doors with good installation procedures can make the use of wooden doors become satisfactory. Chongqing Lang colored wood door has arranged five attention details of wooden door installation for everyone. I hope...
In addition to choosing the quality of the product itself, consumers should not despise after-sales work such as installing wooden doors when purchasing wooden doors. Only good wooden doors with good installation procedures can make the use of wooden doors become satisfactory. Chongqing Lang colored wood door has arranged five attention details of wooden door installation for everyone, hoping to be helpful for everyone in the installation process of wooden door!
1. Appearance should be beautiful: the surface paint film of wooden door should be smooth and bright, without quality defects such as falling, bubbles, wrinkles, etc., without corrosion points, sound knot, and broken; door pocket the wood used should be coordinated with the wood and color of the door leaf. The color difference between the trim board and the wood lines should not be large, and the tree species should be the same.
2. The door leaf should be square and cannot be warped and deformed: The door leaf can just be inserted into the door frame and match the door frame: if the gap between the door leaf and the frame is large, it is mainly because the planing is not correct during installation or the door frame is not perpendicular to the ground. You can remove the door leaf and re-planing it.
3. The hinge should be positioned accurately and installed firmly: If the hinge is not straight, the door leaf will not match the frame cover and the door switch will not be smooth. You can twist a screw on each hinge first, then adjust the fit between the door leaf and the frame, adjust the repair and then tighten all the screws. If the hinge screw is short, or it is nailed in at screw tightening, the screw is not twisted, or the screw is inclined, it will cause the door leaf to go around. The appropriate screws should be replaced. The screws must be straight when they are put on. The screws should be nailed in 1/3 first, and the rest should be screwed in.
4. The door lock should be opened and locked smoothly, and the two parts locked on the door leaf and the door frame should be consistent: if the lock is not properly installed, it will cause the door leaf to switch freely. Remove the bolt plate, repair the tongue groove with chisel, adjust the position of the bolt mouth of the door frame, and then install it. In addition, the opening direction of the door should also meet the requirements.
5. There should be base material in door set: When door set is made of fine wood board or density plate, the basal plate should be fixed on the base keel of the door frame first, and then the lines should be nailed; Door set after the frame is made of wood, planing, planing straight, then assembling and molding installation on the wall, and then covering basal plate and trim board. Tap the door set side panel by hand. If a Air Force Drum Corps sound is made, it means that the bottom layer does not have base plate such as thin wood board, which should be removed and redone.
The above is the wooden door that Chongqing Lang colored wood door has carefully prepared for everyone. Pay attention to the details of the installation. I hope you can avoid detours when installing wooden doors, saving time, effort and worry!
