It rained a short time ago. A friend asked if there was any solution to the leakage of doors and windows in rainy days? This is the right question! The following is an answer from the editor.
It rained a short time ago. A friend asked if there was any solution to the leakage of doors and windows in rainy days? This is the right question! The following is an answer from the editor.
I. Reasons for water seepage
1. The manufacture of doors and windows is not standard
I didn't pay attention to blocking the drainage hole when sticking the tiles on outside window sill. All the rainwater accumulated in the pushing and pulling frame tank could not be discharged out. When it was full, it leaked into the house.
The window should be made of special sealing strips with good elasticity, standard thickness and matching profiles to ensure that the glass bead is tightly pressed and seamless. The sealing strip must be a whole piece, the interface must be selected at the upper part of the window, and it is better to connect it with glue.
2. Irregular installation of doors and windows
now many windows are corner windows, and there are many splicing places. These places should be sealed with sealant. If they are not sealed, it will become a hidden danger of leakage.
3. The gap between doors and windows and exterior walls is not tightly sealed.
After the gap between the wall and the window is filled with foaming agent, disposable silverware set must be used to seal the gap between the window and the wall. Of course, the premise is that the gap cannot be too large.
If the gap is too large, waterproof mortar must be filled and leveled first. After the doors and windows are installed and fixed, foaming agent should be used to fill the windows. After curing, it should be cut flat. Finally, sealant should be applied on both sides of the inside and outside of the outer frame.
II. Solutions
1. Check the leakage position first
if the window itself leaks water, then you can find the one who makes the window to repair it. If the window is not well installed and leaks when it is fashionable, then pay attention.
If there is leakage above, it is OK to put silicon sealant on the joint between the outside window and the wall, and the same method is used on both sides.
If there is underground leakage, first check whether the platform outside the window has gone through the slope. If not, brush some waterproof paint and then polish some slope with cement, then put silicon sealant on the seam of the window and slope.
2. Check the position and sealing condition of the drain hole of the window frame groove
if it is not just facing the window, please seal the original opening and drill again.
If there is a gap, knock off and shovel all the original sealing places, then buy weather-resistant silicon sealant for soft sealing, then seal them with cement mortar, make waterproof, and paste tiles, I believe there will be no leakage after this treatment.
3. Doors and windows need cleaning and maintenance
daily cleaning to keep the surface of the window clean, when scrubbing, try to choose soft gauze or cotton silk, etc., so as not to scratch the surface of doors and windows. Regular maintenance of Windows can prevent water leakage and prolong their service life.
4. Daily inspection
in use, the action should be as light as possible to open and close. When the window is opened, if any obstacles are found, the fault should be eliminated first. High-grade doors and windows, such as internal tilting windows, folding doors and windows, should be operated strictly according to the instructions. Check the joint of window frame and wall frequently.
5. Select doors and windows with excellent quality
of course, choosing a good door and window can avoid all kinds of problems. Nofette doors and windows protect your home from any "harm"! The air tightness, watertightness, heat insulation, sound insulation and safety of aluminum alloy doors and windows are greatly guaranteed, providing more families with healthy, safe, comfortable and happy home life!
