If the glass door is used for a long time, there will be a failure. Then we need to repair the glass door. Floor spring is a part of glass door that will fail. In this case, how should we replace it reasonably and effectively? How to maintain glass door floor spring?
The glass door is not only beautiful, but also easy to use. We can see the figure of the glass door in both public and home space. However, if the glass door is used for a long time, there will be faults, at this time, we need to repair the glass door.
Floor spring is a part of glass door that will fail. In this case, how should we replace it reasonably and effectively? How to maintain glass door floor spring?
I. Replacement method of glass door floor Spring
1. Remove the sandwich panel on the glass door with screws, and then lift the glass door. Remove the top four screws of floor spring and take out the floor spring. Record the deviation of the glass door floor spring and mark the standard position floor spring at the position where the new cross curve needs to be replaced.
2. Chisel the damaged floor spring and surrounding slots and clean the residual ash, and then wipe it with a damp cloth immediately. Then use the brush banana water to brush around the groove pit, make it wet and brush the plain cement slurry or interface agent again.
3. Place the new floor spring in place according to the marked position of cross curve, fix it around with small wooden wedges, and use the bottom of the section steel head with different specifications at the high and low position interlay.
4. Stir the cement of 1:15 as needed, coarse sand "dry hard cement mortar", and the degree of dry hardness is subject to the feeling of moisture by hand, then fill the slot hole in layers and check whether the position of floor spring is accurate in layers during operation. If there is any displacement phenomenon, adjust it at any time.
5. If you want to fill it to the ground level, the hammer will be flat and then use a little water to smooth it.
6. Before completion, check before and after, left and right, high and low deviation and so on, and then cover it with a layer of plastic cloth to keep moisture without losing.
7. Install a new floor spring.
II. Glass door floor spring maintenance skills
1. Glass door floor spring cannot be immersed in water.
2. The switching speed of the glass door should not be too fast, and the speed control button should be adjusted in time. If there is no response, check whether the floor spring is leaking. If there is oil leakage, please replace it in time.
3. The glass door floor Spring allows it to return to position itself during the return process. Do not apply external force, otherwise it may damage the internal components.
4. Glass door floor spring has been used for a long time, the speed and positioning of the door will change, and it needs to be re-adjusted.
The above is the floor spring replacement methods and maintenance skills sharing in the glass door repair brought by the editor. I hope to help you! If you want to know more about the products of doors and windows and related knowledge, please continue to pay attention to Zhonghua door and window network.
(Article Source: install a network, invasion and deletion)
