At present, many family bathrooms have made dry wet separation, dry wet separation in addition to the simple shower curtain separation, the advanced point is to install the shower room, and the shower room is also the most reliable in dry wet separation. There are two types of shower room doors: vertical hinged door and sliding door. Many friends who installed sliding door have met sliding door who can't push. So how is this problem caused?
At present, many family bathrooms have made dry wet separation, dry wet separation in addition to the simple shower curtain separation, the advanced point is to install the shower room, and the shower room is also the most reliable in dry wet separation. There are two types of shower room doors: vertical hinged door and sliding door. Many friends who installed sliding door have met sliding door who can't push. So how is this problem caused?
In fact, it is usually because the bathroom environment is wet and the hanging wheel or return pulley bearing is rusty and cannot rotate. At this time, sliding door accessories need to be replaced. After all, changing the door again is not only expensive but also troublesome, the following is an introduction to how to deal with the incapacity of shower door sliding door.
(The image is from the Internet and deleted)
1. Check whether the sliding door track of the bathroom room is normal
in general, if the sliding door of the shower room cannot be pulled. You can first check whether there are foreign objects in the entire track. If there is any foreign matter, the foreign matter needs to be removed. If there is no foreign matter, you can add some lubricating oil to the track to see if it can move smoothly. Finally, check whether the entire sliding door track is complete and there is no offset.
2. Check whether shower door sliding door installation is normal
because the sliding door of the shower room is often opened and closed during use, it may be that the sliding door of the shower room has deviated from the track during long-term use. Therefore, it is very necessary to observe whether the sliding door of the shower room is correct in the track. If an offset occurs, you need to adjust it. In this case, one end of the sliding door needs to be lifted and then adjusted. Or take down the whole sliding door. Then clear the debris in the track. Finally, the whole sliding door installation will be fine.
(The image is from the Internet and deleted)
3. Check whether the roller skating of the sliding door of the shower room is intact.
In some cases, perhaps the sliding door of the shower room is intact. However, the pulley of the relevant accessories may have been damaged. In this case, we need to take off the whole sliding door. Then remove the pulley and install a new pulley. In this way, the sliding door of the shower room can be used normally. Generally speaking, in the usual process, we should always pay attention to the maintenance of the sliding door of the shower room.
Generally speaking, if there is a situation that the sliding door cannot be pushed, it is roughly that there is a problem with the sliding door Pulley. If you have strong hands-on ability, you can search for reliable tutorial videos online and think about it yourself. Otherwise, we recommend that you ask the merchant for after-sales repair.
(The article comes from the Internet and is invaded and deleted)
