There are ten main steps in the installation process. Easy window network factory direct sales famous brand provides the overall installation process.
The installation process is strictly in accordance with the national label, and the easy window network has been sorted out. Installation process for your reference only,
the installation process is as follows:
1, clean the hole so that the window frame can be put down. If it cannot be put down, properly handle the hole.
2, put the window frame at the hole, move the position of the calibration in the window hole to the two sides; Calibrate the levelness of the window frame. If it is uneven, the lower frame can be padded with wooden blocks. If there is any imbalance between the upper and lower sides, use wooden wedge to adjust it, at the same time, adjust the joint with the wall and the average gap distance of the wall; Pay attention to the gap of the upper frame.
3, after correcting the level, the window frame can be filled with Styrofoam and the foam surface can be dried faster.
4, fix the window frame with an electric hammer. After a facility for children to bore, connect the window frame with the wall with an expansion nail. The third step and the fourth step can be followed by anyone.
5, cut and pull off the prominent part of the Styrofoam with wallpaper knife to ensure that the next silicon sealant is played.
6, clean up the dust or debris between the window frame and the wall, and use glue gun to conduct silicon sealant waterproof operation on the joint between the window frame and the wall to prevent rainwater from flowing into the house from the gap between the window frame and the wall.
7, after installing the window frame, the next step is to install the glass. First, attach the glass curtain wall double-side paste in the window frame and inner cushion on the window frame wooden wedge to prevent the glass from cracking.
When installing the casement, put the glass into the casement and place wooden wedge on the hinge and diagonal to ensure that the casement will not fall down under the switch for a long time, thus affecting the window switch.
8, after placing the glass, stick the double-side paste on the buckle and install it, then seal the inside and outside of the glass, and glue the inside and outside of the glass with glue gun.
9, check the use of hardware and the switch of Casement to ensure the smooth opening of the window. If there is any problem, debug the hardware in time.
10. Clean up the garbage in the house and check it.
The above information is provided by yiwindow.com, and the source is Reprinted and indicated, Factory Direct Sales brand-name authentic, installation process strict specifications.
