Spring Wooden Door Decoration Yilong Solve So Easy

Interior wooden doors are related to their own facade, and decoration is very important. However, because they don't understand home decoration, they often find such and such problems after installation, which is very troublesome. Today, the editor will analyze the common problems and solutions of installing wooden doors, hoping to help you! The following content is for reference only. Please understand if there is any discrepancy!

1. The door frame with face sticking is uneven with the plastered surface after installation

main reason: the thickness of the plastering layer is not well mastered when opening.

Solution: the thickness should be calculated first when plastering, and the gray surface should be smooth when plastering.

2. The reserved size of the door opening is not accurate, and the seam around the door frame is too large or too small

the main reason is that the size of the door opening cannot be set properly during masonry, the size of the remaining allowance is uneven, or the rules for pulling wires during masonry are poor, and the deviation is more.

Solution: Under normal circumstances, the installation of door frame epithelial should be lower than the door lintel10~15mm.

3. The door frame is not firmly installed

the main reason is that the number of wood bricks reserved during masonry is small or the wood bricks are not firm; The installation lightweight wall does not set concrete blocks with wood bricks, but directly uses wood bricks, and the wood bricks shrink after the ash is dried; prefabricated concrete altar or prefabricated concrete partition board.

Solution: The wooden bricks and framework of steel reinforcement should be fixed together during prefabrication, so that the wooden bricks are firmly fixed in the prefabricated concrete. The setting of the wooden bricks must meet the requirements of quantity and spacing.

4. Uneven hinge

main reasons: the screws are loose, the nuts are slanted and exposed, and the screws are missing: the hinge groove is different in depth and depth. When installing, the screws are inserted into the large length, or are obliquely screwed in.

Solution: screws should be nailed when installing1/3, twist people2/3, do not tilt when screwing; If you encounter wood joints during installation, drill holes at the wood joints, and then screw the screws after inserting wooden plug again. At the same time, pay attention to that each hole is screwed properly, and do not miss it.

V. Door leaf warpage

solution: The warpage exceeds3mm yes, it should be replaced or used after disposal, or the warpage of the fan can be solved by adjusting the hardware position.

6. Door leaf switch is not working, self-switch

the main reason is that the two hinge shaft installed on the door leaf are not in a straight line; The door frame upright on one side of the hinge is not vertical; There are many hinge frames, and the fan and the stem collide, causing the switch to be inflexible.

Solution: it is required to check whether the door frame upright is vertical before masking the fan. If there is any problem, it should be adjusted in time, so that the upper and lower hinge shaft of the fan are on a vertical line, and the hardware is suitable, screw installation should be straight.

7. Fan down

the main reason is that the hinge is loose; The hinge is too small or hanging heavy objects and stepping on the door leaf.

Solution: select the appropriate hinge, and screw all the screws that fix the hinge, and make it firm to prevent man-made damage.

Warm tips

1. When installing wooden doors, handle them lightly to prevent damage to finished products;

2. Do not pry hard when trimming the door leaf to avoid damage to the fan material and hardware;

3. Wooden door frame after installation, measures should be taken to prevent the door frame from shifting or deforming after collision, damaging the cutting mouth and affecting the installation;

4. When repairing wooden door frame blades, put the door up and hold it firmly to avoid damaging the door edge;