Many families have automatically closed the wooden door after it is installed. I don't know what causes it. Jiangshan Millennium door industry reminds everyone that the measurement results of door openings have an absolute impact on the installation quality of wooden doors. After measurement, the customized wooden door is relatively easy to install. As long as the measured hole data is accurate enough, there will be basically no problem in the installation.
1 door auto switch
phenomenon: some doors will open or close automatically. Under normal circumstances, if the installation is in place and the wall is straight, the door can be stopped at any seat when it is opened, and there will be no problem of automatic opening and closing.
Crux:1. The vertical direction of the door is not safe; 2. In the old house, some walls are not standard, and the thickness of the wall at the opening is inconsistent.
Solution: during installation, workers can use infrared level to ensure that all lines of the door are vertical. The thickness of the wall should be carefully measured during measurement and leveled in time.
2 door casing has a seam with the Wall
phenomenon: after the door casing is installed, it does not fit perfectly with the wall, but there are some gaps.
Crux: this is related to the thickness of the wall. If the thickness error on both sides and above the wall of the opening is not large, there will be cracks.
Solution: can be marked with white silicon sealant.
3 wooden door push-pull inconvenience
phenomenon: in winter, the door crack will be too large, and in humid summer, the wooden door will be difficult to open.
Crux: wooden door has the property of wet expansion and dry contraction. If the door seam is left untimely, this situation will occur.
Solution: generally speaking, in the longitudinal crack of the door, the seam under the door should be 8-12mm, leaving too much light, which affects the sound insulation effect and is not beautiful; leaving too little will lead to the difficulty of opening wooden doors after wet expansion in summer or falling down for a long time. The horizontal door seam should be left 5mm, usually 2mm on the side of the hinge and 3mm on the side of the lock.
After the workers are installed, the owner must check the door seam by himself: close the door, check whether the door seam is balanced, and whether there is a situation where one side is wide and the other side is narrow. If it is not balanced, it means that the door frame is not secure, it not only affects the appearance but also affects daily use.
