Imitation solid wood door, OK? Sleeve wire the installation should be evenly glued and fixed with door set and wall. The interface of the sleeve wire should be flat, tight and seamless. After installation, the same side should be sleeve wire in one plane. Due to the abnormal wall, how to install the imitation solid wood door? Then, let's take a look at the details.
Imitation solid wood door, OK
Anti-solid wood door is compound solid wooden door solid wood door. The fir lining in the door is all finger-connected and assembled, and the surface is pasted with natural solid wood leather. The line is natural solid wood. The price of this door is about 500, and it is semi-finished products without paint. Plywood craft door is also fir lining material inside, but it is nailed into a lattice shape, with three plywood on the surface. The lines are generally Science and Technology wood, and the price is about 200, which fluctuates up and down according to the price of the three plywood on the surface, semi-finished products do not contain paint.
Imitation solid wood door installation
Door set installation
1. Door set the assembly joints should be tight, flat and free of black seams; Fixed accessories should be locked; Door set diagonal should be accurate, and the allowable tolerance within 2 meters should be less than or equal to 1mm, 2 meters above allowed ≤ 1.5mm
2. After door set is installed, it should be three-dimensional horizontal and vertical, with tolerance of 2mm for verticality and 1mm for horizontal straightness; door set and wall should be combined with fixed screws (no less than 3 per meter); Door set should be installed with a width of more than 200mm; The gap between fixed iron piece and wall should be sealed with door set double-sided seal, styrofoam should be spreadability, and cut flat after drying.
Sleeve wire installation
1. Sleeve wire the installation should be evenly glued and fixed with door set and wall. The interface of sleeve wire should be flat, tight and seamless. After installation, the same side should be sleeve wire in one plane; Due to the abnormal wall, the sleeve wire interface must be smooth. Sleeve wire the allowable tolerance of bending degree is 1mm. Sleeve wire apply sealant to fill the gap with the wall.
Door leaf installation
1. After the door leaf is installed, it should be flat and vertical, and the door leaf should be flat with the exposed surface of door set; There is no abnormal sound when the door leaf is opened, and the switch is flexible and free.
2. The gap between door set and the door leaf, the lower seam is 6mm, and the other three sides are 2mm; All gaps are allowed to have a tolerance of 0.5mm.
3. After the door leaf is tightly closed, it is tightly combined with the sealing strip and does not swing.
So, is there anything unclear about the above content about the installation of imitation solid wood door and imitation solid wood door? I hope it will be helpful to everyone.
Editor: China Door Industry Network-dog thief
