There are many kinds of doors outside buildings. Some buildings use automatic revolving doors. Let's take a look at the repair and maintenance methods of automatic revolving doors, right?
Revolving door maintenance method
1. When the light is on, the emergency stop button of inner and outer sides of the revolving door is started, so the automatic revolving door cannot run. At this time, you only need to twist the button clockwise to unlock it.
2. When the light B is on, check whether the infrared anti-pinching sensor detects foreign matter, and then check whether there is any problem with the column rubber anti-pinching sensor. (Note that both sides should be checked)
3. When the F-light is on, the infrared anti-collision function is started, and the automatic revolving door cannot rotate at this time. At this time, it is necessary to check whether there are foreign objects on both sides of the infrared radiation sensor, or whether the infrared radiation sensor on both sides cannot accurately transmit and receive signals due to the deformation of door body.
4. When using the sliding door function in the middle of the automatic revolving door, if the switch is set to be able to enter and exit, sliding door can be opened but cannot be closed. At this time, trouble light D and F will be on. To eliminate the fault, you can check whether the infrared radiation sensor accurately transmits and receives the signal. When the sliding door can be turned off normally, the D and F lights will go out.
5. When all three groups of trouble light are on, it means that there is no power supply, and the automatic revolving door will change from revolving door mode to sliding door mode, which will not affect traffic.
Revolving door maintenance method
in the maintenance process of automatic revolving door, what needs to be done every time is to unlock from the inspection door and carefully observe whether the revolving door has the phenomenon of threshold scratch or inflexibility. Whether there are signs of looseness between door leaves, changes, and no traces of corrosion between various equipment. If the above problems do not occur, the revolving door can be cleaned directly. The door cannot be covered with too much dust, which will have a certain impact on the door and seriously damage the use of the door.
After the exterior is cleaned, the interior of the door needs to be checked. When repairing the revolving door, the steps are similar. The chassis of the revolving door will be cleaned up after a period of time, which will prolong the service life of the chassis.
If there is a problem with the revolving door, the door needs to be repaired. The maintenance method of revolving door is to check each component on the door to see if there is any looseness. If there is any, it can be reinforced directly. Then check whether these parts are worn, if any, you need to replace the door parts. Then check the pulley. If there is no problem, add lubricating oil often.
Revolving door brand introduction
1. BO AO
boao automatic door Co., Ltd., an automatic revolving door manufacturer, was established in 2004. It is a professional enterprise integrating research and development, design, sales and after-sales. The company is mainly engaged in the sales and production of automatic sliding gate, medical automatic door, automatic revolving door, manual revolving door, industrial automatic door and other products.
2. Jie Shun
chengdu jiesun Automation Equipment Engineering Co., Ltd., a manufacturer of automatic revolving doors, is a professional manufacturer of automatic revolving doors. The company has unique design style, exquisite technical experience and perfect quality after-sales service, which provides a solid foundation for the continuous development of the enterprise.
3. European wing shield
guangzhou ouyidun Intelligent Technology Co., Ltd., a manufacturer of automatic revolving door, is a high-tech enterprise integrating research and development, production, design, installation and service. The company has advanced technical experience and a strong product research and development team has always been in a leading position in the industry.
