In modern decoration, most families use wooden doors for inner door. However, wooden doors play a more decorative role besides practicality. If the wooden doors installed are rough in workmanship, then it will affect the overall decoration harmony. The following small editor will introduce the installation process of wooden doors. Only by installing them step by step and grasping the details can wooden doors have more exquisite visual effects.
1. Preparation phase
As the saying goes, "there is no danger", so the preparation for installing wooden doors cannot be ignored. If the wooden doors are not prepared for installation, big problems will occur during the installation process. Generally speaking, wooden doors are composed of door frames, door leaves, hardware parts and other accessories. Before installing wooden doors, check whether the main pieces of some doors are standard in Specification, damaged, bent, lack of angle and other phenomena, whether the material of the door meets the standards of relevant national regulations, and whether the type, specification and opening direction of the door opening meet the design requirements. In addition, the most important thing to pay attention to is the inspection of accessories, because the accessories are relatively small and easy to be ignored and forgotten by people, so when checking the accessories, they must be thin and thin, it is mainly to check whether the accessories of each part are complete, whether there are signs of rust, and finally prepare installation tools, such as door bars, hammers, rulers, pens, ropes, special firmware, etc.
2. Construction stage
The installation of wooden doors can only be carried out after the basic indoor decoration project is completed. After the installation materials and tools are prepared, the door frame can be assembled, and the overlapping place of the vertical frame and the horizontal frame can be coated with glue, make it more firm, and then fix it with self-tapping screws; Then locate the door frame according to the indoor elevation line to ensure that the gap between the door frame and the door leaf is 2.5~3mm, and the door leaf and the ground are between 5~8mm; then glue the door frame. The glue money should be used to clean the wall, and then fill the wall with Styrofoam after wetting the wall. Do not use too much glue, and grasp the amount; Install door casing and wait until Styrofoam is cured, note that the relative error level of door casing should not exceed 1mm, and the vertical should not exceed 2mm; Finally, when installing the door leaf, pay attention to the opening direction and clearance requirements of the door, and ensure that the door leaf switch is flexible.
3. Acceptance phase
After the wooden door is installed, it must be carefully checked and accepted. This is the last checkpoint for the installation of wooden door, and it is also the final standard for determining whether the installation of wooden door is perfect. Some people see that the appearance of the wooden door after installation seems to be OK, but there is a problem soon after use, so the acceptance cannot be careless and perfunctory. The acceptance of the wooden door is mainly that the direct joint seam between the door line and the ground cannot exceed 3mm, whether the door lock is flexible, whether the components are firm and tight, and finally, whether the overall visual effect of the wooden door is harmonious.
The above three steps of wooden door installation process contains a lot of small details and knowledge. Installing wooden doors is a technical work, and everyone should actively practice and find that there is a doorway.
Editor: China Door Industry Network-dog thief
