Whether the wooden door is installed or not directly affects the use of the wooden door. Of course, there are many details that need attention during the installation of the wooden door. The following describes the installation skills of the wooden door in detail, and solutions to common problems in wooden door installation.
Wooden door installation conditions
(1) the wooden door must adopt the installation method of reserved opening, and the method of installing side opening is strictly prohibited.
(2) the wooden door must be installed after the installation of the floor project (such as floor tiles and stone), and after the putty on the wall is scraped and polished (the wall needs to be wall tile, the holes in the stone must be attached to the side of the holes) before installation.
(3) the humidity of the wall at the entrance of the installation is less than 25%. If the humidity is more than 25%, the moisture-proof isolation layer should be made on the wall.
(4) the installation site has clean environment, no clutter and no cross operation.
2. Installation tools electric hammer, woodworking hammer, plane, flat file, fine tooth saw (hacksaw), screwdriver, Angle Square, tape measure, plumb bob, horizontal ruler, electric drill, Tapper, stamp, and drill with corresponding specifications.
3. Installation material iron sheet connector, 60 iron nails, 25 and 20 self-tapping screws, 502 glue, towel or cotton yarn, wood cutting, small Batten, pig hair brush, Styrofoam, milky white glue, door lock, hinge, door stopper, wall moisture insulation material.
Wooden door installation skills
When installing wooden doors, first check whether all parts of wooden doors are complete, whether the dimensions of each part are correct, and whether the corresponding positions assigned to each set of doors are consistent with the door opening ruler.
1. Please place the goods horizontally on the ground and do not lean against them.
2. Unpainted products should be painted within five days.
3. Try to avoid outdoor sunlight for a long time and prevent wooden doors from heating.
4. Keep the indoor air circulating to prevent the wooden door from being damp frequently.
5. Prevent the wooden door from abnormal impact, and do not use too much force when it is closed.
6. It is forbidden to nail heavy objects on the door.
7. Before installing the corner wall and T-shaped wall door hole, inform the customer to make a "fake wall" on the side without gate stack, with a width of not less than 50mm, determine the width of the "fake wall" according to the width of the line. Otherwise, the edge lines displayed on both sides are asymmetric.
Wooden door installation problem solution
1. Door auto switch
Phenomenon: some doors will open or close automatically. Under normal circumstances, if the installation is in place and the wall is straight, the door can stop in any direction when it is opened, and it will not automatically open or close.
Crux: 1. The vertical direction of the door is not safe; 2. In the old house, some walls are not standard, and the thickness of the wall at the opening is inconsistent.
Solution: during installation, workers can use infrared level to ensure that all lines of the door are vertical.
The thickness of the wall should be carefully measured during measurement and leveled in time.
2. Door casing has a seam with the Wall
Phenomenon: after door casing is installed, it does not fit perfectly with the wall, but there are some gaps.
Crux: this is related to the thickness of the wall. If the thickness error on both sides and above the wall of the opening is not large, there will be cracks.
Solution: White silicon sealant can be marked.
Editor: China Door Industry Network -- 27
