After the completion of home decoration, we will naturally carry out the step of home decoration acceptance, so how should we carry out the acceptance of wooden doors? Next, follow the editor to understand the essential points of the wooden door acceptance.
1. Beautiful appearance
The paint film on the surface of wooden doors and windows should be smooth and bright, without quality defects such as falling, bubbles, wrinkles, etc., without corrosion points, sound knot, and broken; The wood used in the package of window and door sets should be the same as the wood of doors and windows fan, the color is coordinated. The color difference between trim board and Wood lines cannot be large, and the tree species should be the same.
2. The door and window fan should be square and cannot be warped and deformed. The door and window fan can just be inserted into the door and window frame, which is consistent with the door and window frame.
If the gap between the door casement and the frame is large, it is mainly because the planing is not fixed during installation or the door and window frame is not perpendicular to the ground, you can remove the door casement and re-planing; If the door and window frame is not vertical, the gasket inside the frame plate should be straight.
3. Hinge should be located accurately and installed firmly
If the hinge is not straight, the doors and windows will not match the frame cover and the door and window switch will not be smooth. You can twist a screw on each hinge first, then adjust the consistency between the door and window fan and the frame, adjust the repair and then tighten all the screws. If the hinge screw is short, or the hinge screw is nailed in at screw tightening, the screw is not twisted, or the screw is inclined, it will cause the door and window fan to go around. The appropriate screws should be replaced. The screws must be straight when they are put on. The screws should be nailed in 1/3 first, and the rest should be screwed in.
4. The door lock should be opened and locked smoothly, and the two parts locked on the door leaf and the door frame should be consistent
The lock is not properly installed, which will cause the door leaf to switch freely. Remove the bolt plate, repair the tongue groove with chisel, adjust the position of the bolt mouth of the door frame, and then install it. In addition, the opening direction of the door should also meet the requirements.
5. There must be basic materials in window and door sets
When window frame is made of thin wood board or density plate, the basal plate should be fixed on the base keel of the window frame first, and then the lines should be nailed; Door set it is appropriate to use wood to make the frame, planing, planing straight, then it is assembled and installed on the wall, covering basal plate and trim board. Tap the window and door sets side panel by hand. If a Air Force Drum Corps sound is made, it means that the bottom layer does not have base plate such as thin wood board, which should be removed and redone.
Editor: China Door Industry Network-dog thief
