As we all know, the door is the baffle of private home space and the outside world, and its safety and quality are very important to us. Therefore, more attention must be paid to the installation of wooden doors to avoid quality problems caused by some minor mistakes or other reasons.
Error-prone details 1
When carrying solid wood door panels, try to avoid scratching or hurting the door frame and door leaf. When placing the door frame and door leaf, it should also be placed on the indoor horizontal ground without direct sunlight but air circulation. Remember to place the door frame and door leaf diagonally, which is easy to damage the door frame and door leaf.
Error-prone details 2
The wooden door must be installed in the floor project (such as floor tiles and stone) at the entrance, and the putty on the wall should be scraped and polished smoothly (the entrance at the wall needs wall tile and stone, the installation steps of the wooden door can only be carried out after all the sides of the opening are attached.
Error-prone details 3
The installation method of wooden door must use the reserved hole installation method, and it is strictly prohibited to use the method of side installation and side opening.
Error-prone details 4 when installing wooden doors, check the humidity of the wall at the opening. If the humidity of the wall at the opening is less than 25%, the installation can continue normally; If the humidity of the wall at the opening is more than 25%, then the moisture-proof isolation layer should be made on the installed wall.
Error-prone details 5
If a wooden door is installed at the corner wall or T-shaped wall, a "fake wall" with a size of not less than 50mm should be made on the side of the gate stack without plane width before installation ". Of course, the width of the false wall here can be determined according to the width of the line to avoid the asymmetry of the edge lines displayed on both sides.
Error-prone details 6
If the door frame is made of MDF material, screws should be used when assembling the door frame; If the door frame is made of multi-layer board or solid wood boards, iron nails can be used to fix the door frame.
Error-prone details 7
When installing the door frame, you must adjust the verticality of the door frame to avoid damaging the door frame due to the drying and swelling effect of the foaming agent.
Error-prone details 8
Because the two sides of the door frame may be powered by wired lines, the electricity operation must be standardized when installing the door frame.
Error-prone details 9
Confirm the ground forming height and wall thickness according to the decoration baseline when measuring the Mao cave opening.
Error-prone details 10
The reserved size of single vertical hinged door, sub-mother door and double double-door door opening is (the thickness of motherboard is 32mm): the height of the door opening = the height of the door leaf + 40mm, and the width of the door opening = the width of the door leaf + 65mm. Other types of combined doors are determined according to the specific situation (note: the height of the door opening refers to the net height, width and thickness of the door opening, which are also the net size from the ground engineering of the opening).
Editor: China Door Industry Network-dog thief
