Maybe everyone knows how to clean aluminum alloy doors and windows, but sometimes they feel that even if they are cleaned, they still find that the doors and windows are not cleaned up? Don't worry, the editor will teach you how to maintain your own aluminum alloy doors and windows!
The first thing to pay attention to when cleaning aluminum alloy doors and windows is to use neutral detergent or use soft cloth to wet clean water. Generally, the soap and washing powder we use are alkaline, and it is best to avoid using, strong acid and alkali cleaners such as dirty powder and toilet detergent cannot be used, which can easily damage the door material type and cause certain damage to doors and windows.
There will always be such and such problems in the long-used door and window glass. The aging and falling off of the seal wool tops and silicon sealant will cause problems such as air leakage and water leakage, and the rust of screws and screws will cause the door and window frame to loosen. Therefore, if any problem is found, change it in time.
It is necessary to check the parts connected to the frame of aluminum alloy doors and windows frequently, and whether the hardware parts are worn out. Positioning shaft pin, wind brace, floor spring, etc. are vulnerable parts of aluminum alloy doors and windows. Make sure that they are flexible and clean, and regularly add lubricating oil and tighten loose screws.
In areas where rainwater is particularly frequent, metal doors and windows are relatively easy to rust, that is, the surface layer of aluminum alloy doors and windows comes with a protective film. After every rain, the doors and windows wet by the rain should be wiped out in time. Its sliding chute is the same, so water should not be left on it.
Aluminum alloy doors and windows should move lightly during use. Hard pushing and hard pulling are absolutely impossible. Faults should be eliminated first. Generally, the sliding and pulling difficulties are due to the deformation, dust accumulation and rust of doors and windows.
Therefore, in order to keep the ore body clean, especially the cleaning of the push-pull groove, it is necessary to use a vacuum cleaner to remove the dust accumulation wool tops in the groove and the door seal. If you use the push-pull groove for a long time, add some or apply a layer of fire wax oil!
