In architectural decoration engineering, it is common to use aluminum profiles to make doors and windows. Although the sizes and styles of aluminum alloy swing gate opener are different, the construction methods and fabrication and installation methods of aluminum alloy swing gate opener are similar. Today, red oak doors and windows will introduce the installation method of aluminum alloy swing gate opener. If you are worried about installing aluminum alloy swing gate opener recently, come and have a look!
Aluminum Alloy swing gate opener Main components
1. Door frame part: used for frame edge profiles around the door frame and other profiles of the door frame.
2. Vertical hinged door hardware: door handle, fastening parts, etc.
3. The door frame and wall connecting parts: Aluminum Angle profiles with a thickness of about 2mm also need screws of specific specifications.
4. Vertical hinged door glass: it is better to use 3mm thick double-layer glass.
Aluminum Alloy swing gate opener installation method
After we have prepared the above materials, we can start the installation of the door. First, we use the bullet line to find rules, and then deal with the hole of the door, after finding it, bury the connecting iron in the hole. At this time, we will open the purchased aluminum alloy swing gate opener and carry out unpacking inspection, and put it in the required place according to the drawing number. After that, we will check whether the protective film of aluminum alloy is punctured, and then install it aluminium alloy door. At this time, fill some insulation materials in the caulking around the door and clean up the sundries. After that, we will install hardware accessories on aluminum alloy swing gate opener, and then install the sealing strip of the door. If there are other needs, we can also install glass. Here, the editor will tell you more about the installation position of the wall thickness. The best installation position is based on the size on the drawing and the width of the platen. If there is any deviation, in principle, the exposed size on sill plate should be the same.
Aluminum Alloy swing gate opener anti-corrosion treatment
If iron parts are used for fixing when aluminum alloy swing gate opener is installed, anti-corrosion treatment should be carried out. The connectors are preferably made of stainless steel. Secondly, aluminum alloy swing gate opener the anti-corrosion treatment on both sides of the door frame should be carried out according to the design requirements. If there is no design requirements, the anti-corrosion materials should be painted, rubber materials and so on can be used.
Having said so much, I believe everyone has almost understood the installation of aluminum alloy swing gate opener. Don't forget to check whether the hardware is matched and firm with the installation of aluminum alloy swing gate opener after installing the door, finally, if time permits, the wall must be fixed.
Editor: China door and window network -- ak
