Recently, rain has increased in many areas. How can we ensure that doors and windows do not leak? Today, I will give you some tips,
broken bridge aluminum doors and windows although the seal is good, there are silicon sealant sealed and waterproof.
But no matter how good the silicon sealant is, it can't stand the rain soaking for a long time. So how can we ensure that the doors and windows do not leak during the decoration process?
First trick: in
broken bridge aluminum doors and windows after the outer frame is installed, if there is cement sand in the room, it is better to use cement outside the window sill to wipe out a slope after the outer frame is installed for silicon sealant.
In this way, even if the rain is very urgent and heavy, the window sill will not store water, because continuous rain will cause silicon sealant to soak in water for a long time, thus losing the waterproof effect.
Second trick: If your decoration is ready to install shielding window, you 'd better add a layer of water retaining iron sheet or shielding window on the upper part of PVC board.
This greatly reduces the possibility of indoor water seepage. If you do not install shielding window, you can also brush waterproof paint on the external wall if necessary.
If you can do the above two points well, you can ensure that a few more rainstorms will not enter your home.
Through the recent observation of doors and windows, the editor found that
broken bridge aluminum doors and windows leakage mainly shows the following points:
1. There was no drip eaves in the previous building design, which made rainwater flow along the wall to silicon sealant position of the window.
A long time of rain washing will make silicon sealant drum, so the rain will flow into the ceiling along the window frame.
2. Silicon sealant in the outdoor wind and sun, experienced cold winter and hot summer, will cause cracking in some places in silicon sealant.
This kind of water leakage caused by silicon sealant cracking, as long as the cracking position is recoated with a layer of silicon sealant.
3. Another reason is that the rain is caused by backward irrigation, just like continuous rainstorm for 40 hours, making
broken bridge aluminum doors and windows the drainage hole is not timely, which will cause rainwater to pour into the room.
In this case, the wet glass and window frames should be dried in time, and special attention should be paid to wiping the sliding chute water.
Once the window leaks, rainwater flows into the room. If the treatment is not timely, many problems affecting the living environment will occur, such as damp wall, peeling wall, moldy wallpaper, foam floor, etc.
Therefore, every link cannot be taken lightly!
