The decoration of bathroom glass doors has been very popular in all households. Many people choose to install glass doors in bathroom doors. How to install glass door pulley in the installation of bathroom glass doors. Also, we encountered that the bathroom glass door pulley was broken and how to maintain and repair it.
Bathroom installation glass door pulley steps
1. First, when installing the door frame of the bathroom glass door, we need to adjust the level and verticality with a level meter, and then add another screw tightening to fix the wish
2. Then install the door leaf of the bathroom glass door, and then use a wrench to adjust the upper and lower pulley block. When adjusting, you must carefully adjust it. After that, it is highly unified, the left and right sides cannot shake, but it cannot be too tight. If it is too tight, it will be difficult to push, and it will not be so easy to slide.
3. The cooperation between the bathroom glass door pulley and the track should be reasonable. The aluminum oxide should also be smooth and Radian, so that the direction will be smooth. After we put the pulley into the card slot, use the height of adjustable screws to align the space and twist it.
4. After we tighten the fixing screws of glass door pulley in the bathroom, we put the door into the track, use a wrench to adjust the height, and then adjust the orientation of the screws to use.
Bathroom installation glass door pulley maintenance
1. Re-adjust
when you find that the glass door of the bathroom is not flexible enough, you should first check whether there is any dislocation. At this time, you can tilt lower roll to check whether the sliding glass door needs to be reinstalled on the top of the roller. You can try to lower the bottom of the door until the roller bites to the bottom track. Then adjust again to make the door just clamp on the right track.
2. Worse parts
because there are many parts involved in the pulley, once the sliding and pulling of the bathroom glass door is abnormal, it is very likely that a part is damaged. At this time, you can check the roller and various parts. A little damage will affect the overall use effect. Once you find out the reason, you should replace it with a new one in time.
3. Bottom repair
if the dislocation factor is excluded, you can check whether the parts at the bottom of the bathroom glass door are damaged. At this time, you can lift the bottom of sliding door vertically up from the roller of the track to remove the bottom set. Pull the door down away from the top track to loosen the top roll. If the top roller is found to be damaged, a new one needs to be replaced.
