The winter wind is really freezing cold. Everyone stayed at home and turned on the heating and refused to go out. However, even at this time, they still felt not very warm. It seemed that the wind always came through, so what causes air leakage and leakage of Windows? Today, Xiao Bian taught you a few tips to solve the problem of air leakage in aluminium windows, specifically solving the problem of air leakage in aluminium windows.
Aluminium windows air leakage solution
observe what causes the aluminium windows air leakage. If the window gap is too large, you can fill the gap with sealant so that the air will not enter.
If the size of the glass is useless, it may also be as if the glass is not reinforced, shaking back and forth, and the wind will naturally enter. At this time, the gap between the glass and the window can also be filled with sealant, reinforced glass.
If the gap between the aluminium windows air leakage is left over from the installation, the measures that should be taken are that it is best to clean up the gap between the window frame and the wall with the door set first, and then plug it in with the Styrofoam, then fill the gap with cement and sand, and finally repair it!
Now the window material is broken bridge insulation aluminum, aluminum alloy doors and windows and plastic steel windows are the mainstream, but even if you buy plastic steel windows and broken bridge aluminum windows, you should pay attention to the material. If the material is poor, the window will be deformed after two or three years of use. Once it is deformed, the sealing performance will be poor and air leakage will occur, therefore, it also reminds the owners to pay special attention to the material when purchasing windows. If your window is due to this air leakage, you can only find a window manufacturer to solve it.
Another important reason for aluminium windows air leakage is that the sealing parts are faulty. The most common one is the aging and cracking of the sealing strip, which directly leads to the deterioration of the sealing performance of the window. Another one is that Styrofoam is too soft. After several years of use, pulverization occurs, resulting in a larger gap between the window frame and the wall, air leakage is generated. You can replace the sealing strip by yourself, and it is better to use EPDM rubber, or rubber and plastic rubber strips with slightly poor quality. If you can't operate it by yourself, it won't cost too much to replace them with small shop workers who make plastic steel windows on the street. As for styrofoam, it needs to be operated by workers. After Styrofoam is cured, the owner can pinch it by himself, and the quality of the pinch is better.
If you feel that the window glass enters the wind, you can hang thick curtains, which will block some of the wind and make the house feel warmer.
In case of aluminium windows air leakage, we can consider whether the installation is not in place, the quality of materials and the failure of accessories will be caused, and take corresponding measures. Learn the aluminium windows tips for solving air leakage described above.
