At present, there are three common sealing strips on the market, including door fan cover sealing strip, wool tops and adhesive strip. Door fan cover sealing strip is mainly used for sealing between door panel and door frame, wool tops is mainly used for sealing between door frame and door leaf, while rubber strip is mainly used for sealing between glass and door leaf.
On sliding window, rubber strips are usually used to seal, layering and there are special sealing strips and slots on doors and windows. Through the layering and inner fan sealing strips, the glass and frame fans are closer, ensuring the tight shape of doors and windows. Generally, there are the following methods about how to stick the sealing strip of the sliding window with broken bridge.
Broken Bridge sliding window sealing strip how to paste
1. When using sealant to fill and fix the glass, first use rubber strip to squeeze the glass and leave a gap for glue injection. When injecting glue, pay attention to the depth of not less than 5mm, and ensure that the glass is not shaken before the glue is cured.
2. The rubber sealing strip cannot be pulled too tightly during installation. It should be embedded in place to keep the surface straight, in close contact with glass and glazing rebate, and keep uniform force around the glass. Then cut rubber strip off from the Bevel at the corner and inject glue into the disconnected place to make it stick firmly.
3. When installing the sealing strip of wool tops, wool tops is generally installed on the Casement, frame fan and other positions to make the sealing between the frame and Casement better.
4. When installing glass gasket and seam allowance rubber strip, after welding, insert the rubber strip into the notch of the profile with a little force in the correct order and direction, and press the rubber strip head down into the embedded groove. Since the rubber strip belongs to elastomer, it will shrink after being pressed. Therefore, when installing, pay attention to when installing the adhesive strip at the interface of both ends, retract the two ends of the adhesive strip to the middle, leaving a contraction space of 2-3cm, and then cut it short and embed it in the slot.
About how to stick the sealing strip of the sliding window of the Broken Bridge, we must master the methods and skills in the process of room decoration. The above is the introduction about how to stick the sealing strip of the sliding window of the Broken Bridge, hoping to help you better install the sealing strip.
