Aluminium windows, the appearance is simple, beautiful and generous, and the environmental protection performance is high. It can be seen everywhere in home and public places. So what is the installation process of aluminium windows? If you want to know about the installation of aluminium windows, come and have a look.
Aluminium windows installation craft
1. Find rules for playing the line
according to the plane position of the window in the construction drawing, find out the position of the window at the highest level, take its window edge line as the standard, draw the window edge offline with special large line pendant, and mark the window at each layer, for some non-straight edges, Chisel shall be carried out.
The height of the window is based on the 50cm horizontal line of the floor. The height of the window is measured to be leather tag high, and the elastic line is straight. A room should keep the height of leather tag under the window consistent, and each floor should also keep the height of the lower leather tag consistent.
2. Installation position in the direction of wall thickness
determine the installation position of sill plate in the wall thickness direction according to the exterior wall layout and the width of aluminium windows. If the thickness of the exterior wall is different, in principle, the exposed width of sill plate in the same room shall prevail, it is appropriate to extend sill plate into aluminium windows and 5mm below.
3. Anti-corrosion treatment
connection fixture if it is not SST part, anti-corrosion treatment must be carried out to prevent electrochemical reaction and corrosion aluminium windows.
4. Position and temporary fixing
according to the rules found, aluminium windows the installation, and lift it straight and level it in time, and check whether the installation position is correct in time. After no problem, temporarily fix it with wooden wedge.
5. Fixing with wall
use nail gun to fix the connector and the wall, the connector spacing should be less than 600mm, and make concealment acceptance records.
6. Handle the gap between window frame and wall
aluminium windows after the installation is fixed, the gap between the window frame and the wall should be filled with mineral wool as required.
Construction technology of aluminum alloy doors and windows maintenance and maintenance of aluminum alloy doors and windows
7. Glue injection
1) clean up the connection between window frame and wall or stone.
2) use building glue glue injection, the surface of the glue coating should be smooth, smooth, and the width and width are basically the same.
8. Glass installation
1) divide the glass size and specification, and pack leather strap according to the design requirements.
2) fix the glass, after the frame is installed, plug leather strap, leather strap should be flat, no loose, disjointed, falling off phenomenon, the interface around should be coated with sealant. Clean the glass surface.
9. Installation hardware accessories
after being handed over, install hardware accessories and ensure their flexible use.
10. Install aluminum alloy screen window
1) stretch yarn, cut yarn, layering fixed; Excess yarn head should be cut clean with flat shovel.
2) hang car window shade.