Although the system doors and windows products have outstanding performance advantages, they do not pay attention to the maintenance of doors and windows, which will also lead to the reduction of the service life of doors and windows. Therefore, they also need to be maintained and maintained in certain ways at ordinary times, only in this way can we avoid damage to doors and windows as much as possible, thus prolonging the service life of doors and windows and giving full play to their effectiveness.
So how to maintain the system doors and windows specifically? Now tell you 7 common sense of maintenance. Come and learn it.
Aluminum frame maintenance
cleaning broken bridge aluminum doors and windows do not step on the aluminum frame or hold the frame as a support.
Regularly observe whether the sealing strip and silicon sealant fall off
sealing Strip and silicon sealant are guaranteed broken bridge aluminum doors and windows the key to sealing, heat preservation and waterproof should be repaired and replaced in time if it falls off.
Regularly clean doors and windows
broken bridge aluminum doors and windows it can be wiped with soft cloth with clean water or neutral detergent. Do not use ordinary soap and washing powder, and do not use strong acid and alkali cleaners such as stain removing powder and toilet detergent.
Clean up accumulated water in time
after rainy days, you should wipe the raindrop of the glass and door and window frames in time, and pay special attention to sliding chute water accumulation.
Regular inspection of accessories
always check the tightening bolts, positioning axis, wind brace, floor spring, etc., and replace damaged parts and vulnerable parts of aluminum alloy doors and windows in time. Add lubricating oil regularly to keep it clean and flexible.
Correct use of doors and windows
broken bridge aluminum doors and windows in the process of use, push and pull gently, push and pull naturally, and do not force push and pull doors and windows when it is difficult to switch, and eliminate the fault first. Ash accumulation and deformation are the main reasons for the difficulty of sliding and pulling aluminum alloy doors and windows. Keep the door frame clean, especially Slot broaching clean. A vacuum cleaner can be used to remove wool tops of dust accumulated in the groove and door seal.
Regularly check the junction of window frame and wall
check frequently broken bridge aluminum doors and windows at the junction of the frame wall, if it is loose for a long time, it is easy to deform the frame as a whole, making the doors and windows unable to be closed and sealed. Therefore, the screw at the joint should be tightened immediately. If the screw footing is loose, use epoxy strong glue to adjust a small amount of cement to seal.
In broken bridge aluminum doors and windows if we can try our best to achieve the above seven points in terms of use and cleaning, I believe it can be better increased. Broken bridge aluminum doors and windows the service life.
