Fuxuan Doors and Windows Remind You to Pay Attention to the Inspection and Maintenance of the Sunshine Room, So as to Prolong Its Service Life.

With the improvement of public living standard and consumption level, people pay more and more attention to quality life. Sun rooms are usually installed on balconies, terraces or roofs, which are places for people to relax at ordinary times. Therefore, sun rooms have been more and more favored and used by friends. However, it should be noted that the sun room also needs maintenance, so as not to affect its function, and good maintenance can prolong the service life of the sun room. So when we enjoy it in the sunshine room, don't forget to maintain the Sunshine Room. How to test the quality of Sunshine Room In fact, the sun room is a kind of glass house structure that uses aluminum alloy or other materials to build a frame. Glass is mainly used as the wall. Its advantage is that it has high lighting, the extra terrace and garden of the owner can be used. The construction cost is similar to that of steel bar concrete, but the load bearing is lower than that of concrete. The inspection of Sunshine Room glass, the appearance quality is mainly to check the flatness, observe whether there are quality defects such as bubbles, inclusion, scratch, line and fog spots, and the glass with such defects, deformation will occur in use, reducing the transparency, mechanical strength and thermal stability of glass, which is not suitable for engineering. Since glass is a transparent object, the quality can be basically identified by visual inspection during selection. The appearance quality of the Sunshine Room glass does not allow cracks, opaque unmelted objects are not allowed in the glass body, and the welding and poor bonding between the two glass bodies are not allowed. Visually check that the brick body should not have ripples, bubbles and layered stripes caused by inhomogeneity in the glass body. The inner concave of the outer surface of glass bricks should be less than 1mm, the outer convex should be less than 2mm, the weight should meet the quality standards, and there should be no quality defects such as surface warpage, notch, Burr, etc., and the angle should be square. A high-quality Sunshine Room is not only made of good materials, but also made by first-class professionals. How to look at the good and bad performance of a Sunshine Room depends mainly on whether the frame is horizontal and vertical, the joint of the profile is large or small, whether the glue is beautiful or not, and whether there is any leakage. 1. Check frequently Check the connection parts of the sun room frequently, tighten the screw bolt in time, and replace the damaged parts. Locate vulnerable parts of aluminum alloy doors and windows such as shaft pin, wind brace, and floor spring. Check frequently and add lubricating oil regularly to keep them clean and flexible. 2. Replace damaged parts Sealing wool tops and silicon sealant seals are the key parts to ensure the sealing and insulation of doors and windows. If they fall off, they should be repaired and replaced in time. Check the combination of doors and windows and Sunshine Room frequently. If there is looseness for a long time, the whole frame will be deformed, which will affect the normal use of doors and windows of Sunshine Room. 3. Push and pull to let nature take its course, the action should be light When the doors and windows of the sun room are in use, the action should be light, and the push and pull should take its course; If you find any problem, don't pull and push hard, you should first eliminate the fault; Dust accumulation and deformation are the main reasons for the difficulty of push and pull, keep the doors and windows clean, especially the sliding groove clean. A vacuum cleaner can be used to remove dust accumulation of wool tops in the tank and the seal. 4. Do not hold the aluminum frame for support When cleaning the doors and windows of the sunshine room, people should not stand on the frame or hold the aluminum frame for support. Doors and windows can be cleaned with soft sponge and neutral detergent. Do not use ordinary soap and washing powder, let alone stain removing powder, toilet cleaner and other strong acid and alkali cleaners. 5. Dry it in time after rainy days After rainy days, wet glass and doors and window frames should be wiped out in time, and special attention should be paid to wiping out sliding chute water. Sliding chute for a long time, the friction increases, you can add a little oil or fire wax oil. 6. Clean up the sunshine room with skills When cleaning up the stains in the sunshine room, you can use a soft cloth to wipe and test the stains. When the stains are too heavy, you can use toothpaste or special cleaning agent for furniture, etc., and wipe and clean immediately after decontamination. 7. Ensure indoor ventilation The ventilation in the sunshine room should be ensured during use, so that the Sunshine Room will not be used for a long time, and the air in the sunshine room will not appear very turbid. The external top surface of the sun room should be cleaned regularly, which will improve the transparency effect of the sun room. 8. Place green plants More green plants are placed in the Sunshine Room. What they play in the Sunshine Room is not only to beautify the environment, but also to purify the air. The sunshine room is full of vitality. Nowadays, Sunshine rooms appear in the public family users. Sunshine rooms are not only the choice of high-end users, but now it is more and more popular for public owners to install sunshine rooms. At the same time, Sunshine rooms are more and more popular with public customers. I don't know if you have learned the Sunshine Room maintenance common sense provided by Xuan Xuan to a large number of users today. [This article is reprinted from fuxuan public account. Only information is transmitted. Please contact us to delete the infringement]] Edit: doors and windows online-Yanzi