Key Points That Must Be Paid Attention to When Installing Broken Bridge Aluminum Doors and Windows

Broken bridge aluminum doors and windows clearance

usually, when people install doors and windows themselves, there will actually be gaps, but the way they deal with is actually very simple. Usually, some hard plastic or other things are clamped in the gap. In practice, it is easy to leave a gap, because these profiles can not connect the wall better, so the sealing performance of doors and windows will be greatly reduced, and the correct treatment method is to use a special method. This material better blocks these analyses, so its sealing performance will be better, and it is helpful for sound insulation and window insulation.

Kitchen bathroom doors and windows

in fact, before everyone thought that the requirement of bridge-cutoff aluminum alloy doors and windows was good sealing performance, but to tell the truth, it is not necessary in the kitchen and bathroom, but if the windows in the kitchen are large, it is recommended not to make casement window. In fact, the window style or sliding window opening up and down will be better, and the best way is to make hanging windows. The sealing requirements of these places are not very high, because windows are usually opened for ventilation, but the final suggestion is to install guardrails outside the windows to ensure the stability of the windows and prevent the danger of falling down.

Broken bridge aluminum doors and windows use of Styrofoam

in fact, there are strict requirements for the use of foamed polystyrene. In the installation broken bridge aluminum doors and windows when, we must pay attention to the gap between the frame and the window wall. Generally, the Wall should be kept at about 1cm. The distance is actually just very good, because too large or too small gap in the middle will affect the use of Styrofoam. If it is small, polystyrene foam is not easy to enter, it is likely to cause the risk of water leakage, but if the gap is too large, it is likely to appear not strict, the most important thing to pay attention to is, the inside and outside of doors and windows should remember to make Styrofoam, because only in this way can the sealing effect of doors and windows be improved. Then consumers should pay attention to the choice of expandable polystyrene. Generally, ordinary Styrofoam actually presents a white state. Once the gel solidifies, it will be very firm, but if the quality is good, the poor Styrofoam color will be light yellow, the best way to distinguish is that inferior expandable polystyrene actually have pungent smell. This is obvious, but the life span of this fake expandable polystyrene is very short. With the passage of time, this inferior gel gradually ages.

Broken bridge aluminum doors and windows installation glass

everyone needs to use Styrofoam when installing doors and windows, so it is also true when installing glass. Before installing, you must remember to clean the glass. In fact, the dust inside is basically installed and cannot be seen. Another point is to pay attention to the use of silicon sealant, because the purpose of silicon sealant is actually to improve the sealing performance of windows, and it is also very helpful for the sound insulation of windows, so I suggest you remember to make glue.

Do you still remember the above points? In fact, these points are the most effective for everyone. In this case, the above points are installation. Broken bridge aluminum doors and windows key points that must be paid attention.

(Article Source: Official website of Bosen special color window, invasion and deletion)