Wooden door is a very popular door in home decoration, but it may be deformed after being used for a long time. What causes the deformation of wooden doors? Is there a solution? The following is an answer for everyone.
Causes of wooden door deformation
1. Damp
the high moisture content of wood is also another major reason for the deformation of wooden doors. With the decrease of moisture content during use, the internal stress of wood will be gradually revealed, which will eventually lead to deformation and cracking.
2. Design structure
whether the design structure of wooden door is reasonable (including internal); Whether it is made according to the technological requirements in actual production; Whether the binder is fully solidified; Whether the Transportation and placement meet the requirements; environmental conditions in the place of use are also important reasons for the deformation of wooden doors.
3. Material problem
whether it is solid wood door, or composite door of solid wood have wood components, and wood, like other objects, has the characteristics of dry shrinkage and swelling. Wood logs are natural, and the degree of variation is more serious than synthetic materials. Moreover, the wooden door has a large area and few fixed points, so it is most prone to deformation and cracking.
What should I do if the wooden door is deformed?
There are several kinds of deformation of wooden doors. One is pseudo deformation, which is caused by changes in the usage environment. If the window is open and the winter is dry and cold, the side of the door next to the window will easily form a "pan bottom Bend" (bending towards the window); When the summer is hot, the door is easy to form a "Archway Bend" (curved toward the interior). However, after a year of four seasons change, the door will tend to stabilize.
However, some deformation is a quality problem. For example, the selection of materials is unreasonable. The Wood must meet the moisture content requirements of Beijing, and too high or too low will cause the deformation of the door leaf. The plate and the door core are bonded together by white latex under pressure, and the solidification fastness should be guaranteed to be the same, and the door leaf cannot be moved freely before the white latex is fixed and formed. If the solidification time is shortened, it is easy to cause the door panel and the door core to stick firmly, thus causing deformation. However, some bad manufacturers find that the door is curved after being made, and it is very likely to use corrective appliance to make the door hard compaction straight. What consumers buy are all good doors, but in about a month, the doors will slowly turn back and turn, which is what consumers call "deformation". This kind of door has to find a manufacturer.
Long-term damp will also deform, for example, in some small toilets (toilet decoration effect diagram), if water drips on the door, the door will inevitably deform. Generally speaking, if the deformation is found after one month, and the back door still does not reply after 2-3 months of observation, it can be basically identified as a quality problem, and the manufacturer can be required to handle it.
When buying wooden doors, we should try our best to buy good brand credibility, which can ensure better after-sales service. If your wooden door also has such a situation, you can do it according to the above methods.
