With the improvement of living standards, people pay more attention to the pursuit of quality of life. As an extremely important part of Chinese concept, "home" is often paid special attention to home decoration. Door and window design is an important part of home design. Good door and window design can not only improve the appearance of home, but also provide better guidance for practical experience of home.
▲ fuxuan customer case
01
on the premise of meeting the ventilation requirements of the room, the number of Open fans should be reduced as much as possible. Setting less opening fan can reduce the cost of doors and windows, improve the watertightness, air tightness, thermal insulation and other properties of the whole window, and even expand the view of doors and windows to make the whole window have better permeability.
02
the design of door and window grid should also be coordinated with the facade of the whole building. The height of doors and windows on the same floor must be corresponding, and the width of doors and windows at the same elevation must be corresponding to improve the facade effect of doors and windows and buildings.
the opening design of doors and windows should fully consider whether the opening position conflicts with the room structure and furniture layout (whether the ventilation is smooth, whether the opening is barrier-free, whether the opening process of 90 degrees scratches the articles in the room, whether it causes inconvenience to indoor activities after opening).
in the aspect of opening fan width design: the flat open pour inside window should be controlled at about 650mm-900mm, and the single in-swinging casement window should be controlled at about 600mm-650mm. The opening of the flat pour inside window is mainly in the state of Pour inside. If the fan width is too small and the upper hanging opening is small, the ventilation will be affected.
The opening method of single in-swinging casement window is mainly internal flat opening. If the width of the fan is too wide, it will occupy indoor space after flat opening, and Casement is easy to fall, increasing the maintenance volume. The width of the outer casement window fan should be controlled at about 450mm-650mm. If it is too wide, it will easily cause the inconvenience of opening the outer and the insufficient load bearing of the friction hinge. The height of outer casement window should also be controlled within 1500mm.
door height design should not exceed 2400mm, door leaf width should not exceed 950mm.
when designing arc fixed windows, the middle part (arch top) should not be designed with vertical standing to avoid blocking the sight.
07
the design of the width of the inner open fan and the width of the outer open fan needs to consider the installation requirements of the minimum slot width of the hardware: the minimum slot width of the flat open pour inside Casement is required to be 400mm, and the minimum slot width of the outer flat open fan is required to be 204mm.
the principle of equal division or Golden Division ratio should be taken into account in the proportion of light on the window, side brightness and opening, and the design of unequal division should be taboo. When the design has horizontal middle height, we must consider the horizontal height from the ground to avoid affecting people's observation vision.
the design of fixed windows size should consider the strength requirements of glass and the feasibility of processing, handling and installation. Generally, the surface of 5mm hollow glass plate should not be greater than 1500 mmX1600mm, and the area should not be greater than 2.5?.