Sliding window it has the advantages of not occupying indoor space, beautiful appearance, economical price and good sealing performance. High-grade slide rail is adopted, and it can be opened flexibly with a gentle push. With large pieces of glass, it not only increases indoor lighting, but also improves the overall appearance of the building. Casement is in good stress state and not easy to damage, but the ventilation area is limited to a certain extent, and can only be opened by half at most. The ventilation is relatively poor; Sometimes the sealing is also slightly poor.
Sliding window daily maintenance
1. After the doors and windows are installed, tear off the protective film on the surface of the profile in Time and scrub it clean; Otherwise, the protective film adhesive will remain on the profile in large quantities, which is difficult to clean.
2. Sliding window when using, the push-pull track should be cleaned frequently to keep it clean, so that there is no hard particle material on the track surface and groove.
3. Plastic steel doors and windows have drainage systems in window frames, Casement and other parts to ensure the air tightness and water tightness of doors and windows. Users should not block the drainage holes of doors and windows during use, in order to avoid the degradation of the drainage performance of doors and windows.
4. Sliding window when pushing and pulling, the force point should be in the middle or lower position of Casement. Do not push and pull too hard to avoid reducing the service life of Casement.
5. The gauze fan can remove the adhesive strip fixed by voile, take voile, and wash it with water-soluble detergent respectively.
6. When using the sliding window gauze fan, please pay attention to the coincidence with the vertical frame of the inner rail push-pull fan to maintain good sealing performance.
Sliding window hardware introduction
1. The standard type is called Crescent lock sliding window. The required hardware accessories are composed of semi-garden lock and needle roller Pulley type C. By rotating the semi-garden lock handle, the closed two sliding windows are locked. This window type is low in price and easy to install. It is currently the most acceptable and widely used window type for the majority of door and window units and users.
2. The mid-range type is called Spring lock sliding window, and the required hardware accessories consist of spring lock, single-point lock, needle roller Pulley type B and auxiliary parts. This window type is more beautiful and easy to operate than the standard window type, but the installation spring lock must be milled.
3. High-grade is called dark handle or actuator sliding window, and the required hardware accessories consist of dark handle or standard handle, transmission lock, single-point lock (slide fastener), needle roller Pulley type A and auxiliary parts, etc, by turning the handle, Casement after closing can be locked at two points. Compared with standard and mid-range window, this window type has increased anti-theft, beautiful appearance and long service life, and is the preferred window type for high-end villas and key buildings.
